Original Treadmill Motor Controller MC2100ELS-50W-ZY MC2100ELS-50W-2Y Lower Control Board Power Supply Board for ICON PROFORM

How to determine the failed controller

E01: communication failure, sensor failure;
E02: you'd better test the motor first to check if there is any problem with motor, if motor work normal, then need to change controller.
E03: Sensor fault; treadmill will run few seconds then show E03;
E04: usually over-current fault, this situation is generally burned components on the controller;
E08: May be lift motor control fault.

Test Motor

Make sure the motor run normal by testing
Please make sure that there is no problem with the motor before you place your order.The motor can be tested by the method shown in the picture below. If the motor running smoothly by 2*5# battery, that means the motor is good. If running not smooth or do not run, it means motor broken.

REMINDER

Spare parts are different from other products in that they involve some professionalism. For example, issues such as installation, compatibility, and calibration. When you receive our product, please do not lock the screws, but insert the wires and test them first. If everything is functioning properly, you can install and lock the screws. If you encounter any problems during testing, please contact us and we will do our best to assist in resolving the relevant issues. If it cannot be resolved, we will also provide a solution.
If you encounter any problems, please do not directly raise disputes or return the goods. Please contact us first. Thank you very much!